brakes

1980 CHEVROLET CORSA
5 CYL
Avatar
ROBERTWHIT
  • MEMBER
  • 2 POSTS
brakes go to floor, replaced lines, master cylinder, bleed them what can it be? someone said power booster???
Mar 29, 2011 at 9:58 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
Recheck the master cylinder could be leaking internally though its new-Engine off pump brake pedal a few times till exhaust it and hold it in-start the vehicle up the brake should sink in a little if the booster is doing its job. Double check for external leak all around-
Mar 29, 2011 at 11:54 PM
Advertisement