transmission bellhousing

1979 FORD BRONCO
91,000 MILES • V8 • 4WD • AUTOMATIC
Avatar
SOUTHERNSHOCKER
  • MEMBER
  • 1 POST
is there a inspection plate on a c6 transmission bellhousing that can be removed to bolt the torque converter to the flywheel when i put my motor back in i looked earlier and didnt see anything that can be removed thnx. it a 79 ford bronco with 400 motor
Feb 21, 2011 at 5:19 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
MHPAUTOS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 31,937 POSTS
This is to old for the data base, but normally there is a lower plate (bottom section of front of bell housing) of if this is a one piece housing, you will access the bolts from the starter housing.

mark (mhpautos)
Feb 21, 2011 at 11:18 AM
Advertisement