1977 Chevrolet Corvette Looking PCM ECM Fuse Install Forced Ignition Disabling

1977 CHEVROLET CORVETTE
12,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
looking for pcm or ecm fuse for an install of a forced ignition disabling system. or do I just hook up to a battery and add a fuse. 77 vette
Apr 6, 2013 at 6:39 PM
Advertisement
Avatar
FREEMBA
  • ✓ASE Certified Mechanic
  • 1,152 POSTS
  • ASE Certified Mechanic
1977 corvette doesnot have a PCM or ECM or computer forthat matter. To disable this system, you can run a wire from the BAT termnal on the distributor cap to your disable switch and then to ground. flip the switch to off and the car can not be started, though the engine will spin over.
There should be an ignition or power fuse in the fuse box under the dash on the drivers' side.
Apr 6, 2013 at 7:01 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.