1976 FORD F-100
100,000 MILES
Avatar
RMCOX69
  • MEMBER
  • 4 POSTS
What else could be wrong? Can not get to crank after replacing the fuel line, fuel pump, and cleaning the dist. cap. There is no fuel going to fuel filter.
Feb 26, 2013 at 6:34 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
DOCFIXIT
  • CAR REPAIR CONTRIBUTOR
  • 18,828 POSTS
Was no fuel to engine the problem before repairs? is line to tank clear no restrictions? what fuel line was replaced ?
Feb 26, 2013 at 6:38 PM
Advertisement
Avatar
RMCOX69
  • MEMBER
  • 4 POSTS
no fuel to engine, short fuel line from tank to chases was leaking replaced that . yes, line is clear fuel is in line halfway up the truck underneath bed on driver's side at chases.
Feb 26, 2013 at 7:26 PM
Avatar
DOCFIXIT
  • CAR REPAIR CONTRIBUTOR
  • 18,828 POSTS
Do you have a vacuum guage? if yes place on pump inlet crank is there vacuum? if yes can you siphon gas to pump? if yes prime carb and start it may pickup and run
Feb 26, 2013 at 7:35 PM
Avatar
RMCOX69
  • MEMBER
  • 4 POSTS
the no fuel to engine was not the problem before repairs, the problem was the small fuel line from tank to chases it was leaking. the no fuel to engine came afterward
Feb 26, 2013 at 7:58 PM
Avatar
RMCOX69
  • MEMBER
  • 4 POSTS
no vaccum to gauge
Feb 26, 2013 at 8:05 PM