C6 Transmission Swap

1976 FORD E-SERIES VAN
200,000 MILES
Avatar
RANGER812572
  • MEMBER
  • 52 POSTS
My transmission went out. I have an opportunity to pick up a C6 from a 460. Problem is I have a 351 Windsor, and I need to know if it will bolt up, or if there is an interchangeable bell housing.
Nov 10, 2011 at 7:45 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
DRCRANKNWRENCH
  • CAR REPAIR CONTRIBUTOR
  • 3,380 POSTS
The C6 is made for big blocks. You would be looking for a C4 transmission.
Hoverer, depending on the spline count and dimater of the input shaft, you may find an adpater plate kit.
Check with Perfamce Automatic on-line. They are one of the top Aftermarket tranny builders and if there is a kit, they will have it.
Nov 10, 2011 at 1:31 PM
Advertisement