1975 Datsun 280z Acceleration under load

1975 DATSUN 280Z
81,000 MILES • 2.8L • 6 CYL • RWD • AUTOMATIC
Avatar
SLASHER
  • MEMBER
  • 2 POSTS
I have checked fuel pressure, replaced injectors, checked for bad wire grounds, replaced water temp sending unit at front of engine. Car still won't run out in gear. Runs out @ 6000+ Rpm in park or neutral.Is this possibly related to exhaust gas pressure?
Sep 8, 2014 at 4:47 AM
Advertisement
Avatar
JACOBANDNICKOLAS
  • CERTIFIED EXPERT
  • 110,175 POSTS
I'm not sure I understand. What do you mean it runs out at 6K RPM's in park or neutral? As far as the exhaust, is there a catalytic converter on it?
Sep 8, 2014 at 5:01 AM
Avatar
SLASHER
  • MEMBER
  • 2 POSTS
The engine will run up in rpm in park or neutral, but when in gear and you try to accel it falls on its face, chokes, sometimes backfires. It has a cat. Thanx, Ken
Sep 10, 2014 at 12:54 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • CERTIFIED EXPERT
  • 110,175 POSTS
You could check back pressure to see if the converter is plugging. Also, often times, they will get red hot if they are plugged. Other than that, you should check ignition timing as well as the ignition advance.
Sep 10, 2014 at 5:21 PM