1971 Ford Ltd Engine Turns Wont Start Sounds Struggling Car Just Died On Out

1971 FORD LTD
56,000 MILES
Avatar
GREGBIGGSSR
  • MEMBER
  • 1 POST
Engine turns but wont start up. Sounds like its struggling. Car just died on me like it was out of gas one day spit out white smoke right before and havnt been able to get it running right since. Went to two shops one said they had no idea. The other said valves may be stuck and the vacum test read 300 when it should be at 500? II love love love this car and will Never ggive it up. Dual steel exhaust original exterior/interior and paint hardtop and coincidence should have it im a punk rocker and this is the same car from my favorite punk rock movie Suburbia from 1982 I am in love with my car and its my 2nd car ever please help!
Jan 5, 2013 at 1:42 PM
Advertisement
Avatar
ASEMASTER6371
  • ASE Certified Mechanic
  • 52,796 POSTS
  • ASE Certified Mechanic
start with basics first. compression, fuel , spark test.

vacuum readings given to you make no sense. cranking vacuum is different than that. compression test will help clear that up.

Roy
Jan 5, 2013 at 2:48 PM
Avatar
HMAC300
  • ASE Certified Mechanic
  • 48,601 POSTS
  • ASE Certified Mechanic
just to add to this check your timing chain it's probably a tooth or two off
Jan 5, 2013 at 3:51 PM
Avatar
CADILLAC CAZ
  • MEMBER
  • 1 POST
i have a 1978 ltd 2 that did the same thing so may be this will help it ended up being the control module but yours is a 71 it may be the points in the distributor to chek take the coil wire off and see if it wil ark off the motor (grond it out and lok for spark
Jan 17, 2013 at 8:20 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.