flywheel

1964 FORD RANCHERO
200,000 MILES • 2WD • MANUAL
Avatar
MYOFF ISH
  • MEMBER
  • 1 POST
What is flywheel diminsion from clutch surface to pressure plate mtg surface. Had flywheel refaced and not sure both surfaces were faced the same. 1964 ford ranchero, 4cyl. new pressure plate,clutch & brg replaced. Clutch would not release.
Dec 29, 2010 at 6:24 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
HMAC300
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 48,601 POSTS
Usually the refacing only taeks off a few thousandths of an inch. If it's not releasing you may have put teh disc in backwards as some will aloow that to happen. Make sure you have about 1/8" clearance at the release arm as well as making sure your release arm isn't bent.
Apr 7, 2011 at 8:40 PM
Advertisement