1962 Ford Ranchero clutch

1962 FORD RANCHERO
48,000 MILES
Avatar
BOBBY A MITCHELL
  • MEMBER
  • 1 POST
i replaced the clutch rod return spring,and now the clutch will not disengage. i can move the clutch fork by habd under the car and all the linkage is still good. the clutch fork appears to go all the way back as it should to engage clutch,and the pedal is on the floor,but car is still in gear
Nov 3, 2013 at 1:52 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
CJ MEDEVAC
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 11,004 POSTS
SEE ANY GREASE (90 WEIGHT) SLUNG AROUND?

IF THE FRONT TRANNY SEAL IS LEAKING, THAT'LL MAKE THE DISK ADHERE TO THE FLYWHEEL

THE MEDIC
Nov 3, 2013 at 7:03 PM
Advertisement
Avatar
HMAC300
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 48,601 POSTS
sounds like abad clutch to me yo may have pushed the release bearing through the pressure plate.
Nov 4, 2013 at 6:47 AM