Car just turned off when I turned a corner and would crank over but not start. Replaced the MAP sensor already and yes it's getting fuel.
Jul 7, 2020 at 10:49 AM
Shut off while turning, cranks no start
2002 OLDSMOBILE BRAVADA
AMY JO EDDINGER
- MEMBER
- 2 POSTS
- FOLLOW
Advertisement
Good afternoon,
Do you know the actual fuel pressure? That is critical. You need 48-54 pounds for the van to run.
https://www.2carpros.com/articles/how-to-check-fuel-system-pressure-and-regulator
https://www.2carpros.com/articles/car-cranks-but-wont-start
Do you know if it has spark? If you have a tachometer on the dash, does it move up a little when you crank it?
https://www.2carpros.com/articles/how-to-test-an-ignition-system
Is the check engine light on? If it is, can you give me the codes?
https://www.2carpros.com/articles/checking-a-service-engine-soon-or-check-engine-light-on-or-flashing
Roy
Do you know the actual fuel pressure? That is critical. You need 48-54 pounds for the van to run.
https://www.2carpros.com/articles/how-to-check-fuel-system-pressure-and-regulator
https://www.2carpros.com/articles/car-cranks-but-wont-start
Do you know if it has spark? If you have a tachometer on the dash, does it move up a little when you crank it?
https://www.2carpros.com/articles/how-to-test-an-ignition-system
Is the check engine light on? If it is, can you give me the codes?
https://www.2carpros.com/articles/checking-a-service-engine-soon-or-check-engine-light-on-or-flashing
Roy
Jul 7, 2020 at 11:09 AM
Unfortunately I do not know the fuel pressure. Yes, my check engine light is on but I do not know the codes I cannot get it any where to put it on a scanner.
Jul 7, 2020 at 5:13 PM
Okay, these items need to be checked.
Do you ave someone who can help with the code reading and the fuel pressure test?
Roy
Do you ave someone who can help with the code reading and the fuel pressure test?
Roy
Jul 7, 2020 at 5:34 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.