1994 Honda Accord

LSWRIGHT

MEMBER
1994 HONDA ACCORD

Engine Mechanical problem
1994 Honda Accord Front Wheel Drive Automatic

have a 94 hunda accord dx with a 16 valve single over head cam. Replaced the head with a 95 hunda vtec 16 valve single over head cam. Having problems in setting the timming. Can't seem to get the timming belt adjusted. Please, need your help.

3 Replies

MHPAUTOS

MECHANIC
31,937 POSTS

HI there,

These are two different head and the timing belt for the vtec and non vtect engine is different,

Vtec P/N 14400POA004
NON v/tec 14400PTO004

which belt are you using.

Mark (mhpautos)

SPONSORED LINKS

Was this

answer

helpful?

Yes

No

Sunday, September 13th, 2009 AT 5:43 AM

LSWRIGHT

MEMBER
3 POSTS

Thanks so much for your responce. I got the belts from advance auto parts. One belt is 95168 and the other is 95187. I don't know witch one is the balance belt no. Did run the engine, but the timming belt so loose, it made the engine hunt. Did not have any accessories hooked up. Just wanted to know if it would run. Thanks agin for your anwser, I will get the right belt eventhough Advance said they were the same belts.

Was this

answer

helpful?

Yes

No

Tuesday, September 15th, 2009 AT 4:25 PM

LSWRIGHT

MEMBER
3 POSTS

Put the right timming belt on and everythings in time. Started engine, and notice engine runs bad, oil pumping out of head (right rear side, ) looked in honda repair manual and noticed head needs a VTEC solenoid where the oil is coming out. IF I get this solenoid, is this it? Or do I need something els? Hoping the head don't have to come off just because the engine block is not vtec in this 94 hunda dx. HELP!

Was this

answer

helpful?

Yes

No

Thursday, September 17th, 2009 AT 8:50 PM