front wheel hub replacement

2000 CHRYSLER INTREPID
246,000 MILES
Avatar
STEVE49
  • MEMBER
  • 3 POSTS
I am trying to change the front wheel hubs on my 2000 Chrysler Intrepid. The after market parts and the O.M.E .parts do not fit. The original parts that I removed have a 1/4 inch collar on them and the O.M.E.and after market parts have about 3/4 inch collar. The receiver for the wheel hub assembly has only enough room for the 1/4 inch collar. I have gone to the dealer with the VIN number for the car and they tell me that the parts they have should fit. Is there some extra parts that I need to make these other parts fit?
May 25, 2013 at 1:10 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
DOCFIXIT
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 18,828 POSTS
Intrepid is a Dodge is this a Canidian made car?
May 25, 2013 at 1:22 PM
Advertisement
Avatar
STEVE49
  • MEMBER
  • 3 POSTS
According to the ownership and the door panels, it is a Chrysler.
May 25, 2013 at 1:35 PM
Avatar
STEVE49
  • MEMBER
  • 3 POSTS
And as far as I know it is Canadian made. If it wasn`t you would think the dealer would have let me know.
May 25, 2013 at 1:37 PM
Avatar
DOCFIXIT
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 18,828 POSTS
Part will be different see if you can get the Temkin # off old bearing. Asume live in USA?
May 26, 2013 at 11:38 AM
Avatar
DOCFIXIT
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 18,828 POSTS
Go to NAPA with bearing there are two the Canidian bearing is different they should be able to match Timkin #
May 26, 2013 at 11:50 AM