WHAT CAUSES A PISTON TO BREAK AFTER NEW HEADS HAVE BEEN INSTALLED
Dec 8, 2008 at 5:53 PM
1996 Ford Windstar PISTONS
1996 FORD WINDSTAR
BEAR60
- MEMBER
- 1 POST
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
Hi there,
It could depend on where the piston failed, can you post a pic? Is there damage on the crown? has a skirt failed? different things can cause a piston failure. it may have been just the increased pressure in the cylinder as just to much for the old piston, if it has failed around a ring land, i would be suspecting this.
mark (mhpautos)
It could depend on where the piston failed, can you post a pic? Is there damage on the crown? has a skirt failed? different things can cause a piston failure. it may have been just the increased pressure in the cylinder as just to much for the old piston, if it has failed around a ring land, i would be suspecting this.
mark (mhpautos)
Dec 8, 2008 at 11:42 PM
Advertisement