2000 Dodge Intrepid high idle

2000 DODGE INTREPID
145,000 MILES • 6 CYL • FWD • AUTOMATIC
Avatar
MOPAR12
  • MEMBER
  • 3 POSTS
Hi, I put together a dodge intrepid, that needed the heads put back on the car.. Have the car together to start it, and it starts and immediatley goes to 4200 rpm and stays.. The car has sat with a bad battery for at least 7 months.. Any ideas on why it idles so high.. I have tested the tps and the throttlebody and everything is good..
Nov 9, 2008 at 12:12 AM
Advertisement
Avatar
LEGITIMATE007
  • ASE Certified Mechanic
  • 5,121 POSTS
  • ASE Certified Mechanic
check for vacuum leaks, thats usually the culprit, check for disconnected vacuum hoses, maybe a pinched one.
Nov 10, 2008 at 6:38 AM
Avatar
MOPAR12
  • MEMBER
  • 3 POSTS
I checked the vacum lines everything correct.. It is idleing at rev limiter.. about 4200rpm.. Like throttle is wide open.. The throttle is closed..
Nov 13, 2008 at 11:09 PM
Avatar
BLUELIGHTNIN6
  • ASE Certified Mechanic
  • 16,542 POSTS
  • ASE Certified Mechanic
It could be many problems that would cause a high idle such as this, but most common issues I have see are: faulty idle control solenoid..MAP sensor...IAC valve. Check those and ensure they are connected properly and wires are not loose.
Nov 13, 2008 at 11:32 PM
Avatar
LEGITIMATE007
  • ASE Certified Mechanic
  • 5,121 POSTS
  • ASE Certified Mechanic
awesome bluelightning, that is correct
Nov 14, 2008 at 7:49 AM
Avatar
MOPAR12
  • MEMBER
  • 3 POSTS
thanks for the help fellows. There were quite a few probs 1. iac, 2. tps, 3. hose to egr not pushed in fully..
Dec 2, 2008 at 6:46 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.