SPONSORED LINKS

2005 Chevy Venture Replacing Wheel Bearing Hub

Tiny
AUTONUT50
  • MEMBER
  • 2005 CHEVROLET VENTURE
  • 6 CYL
  • FWD
  • AUTOMATIC
  • 90,000 MILES
I am replacing wheel bearing hub assembly; I have loosened the hub from steering knuckle, but am not able to remove the hub assembly from the end of the axle. I have used hammer, but will not loosen to slide off.
Any suggestions?
Monday, March 15th, 2010 AT 12:15 PM

2 Replies

Tiny
BLUELIGHTNIN6
  • MECHANIC
  • 16,542 POSTS
Have to use front hub spindle remover service tool to push the drive shaft out of the bearing/hub assembly.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
+1
Monday, March 15th, 2010 AT 4:29 PM
Tiny
HEYOU100
  • MEMBER
  • 6 POSTS
I have a 2004 Venture. You'll need a 34mm deep socket to remove the axle nut. Once removed, tap the axle back toward the engine a little. Undo the three bolts to the bearing hub and tap (hit, smash) it off with a hammer - couple hits on the left side, couple on the right.
Was this
answer
helpful?
Yes
No
+2
Thursday, April 22nd, 2010 AT 6:58 PM

Please login or register to post a reply.

Related Bearing Hub Replace/Remove Content

Sponsored links