SPONSORED LINKS

2015 Nissan Rogue Lack of knowledge

Tiny
DKIRK
  • MEMBER
  • 2015 NISSAN ROGUE
Simple problem, where are the fuses located in 2015 Rogue?
Tuesday, February 24th, 2015 AT 1:05 PM

6 Replies

Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,885 POSTS
It's located on the side of the dash (driver's side) page 8-23 of the owner's manual. If you didn't get the manual, check this site and go to the page I listed above.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Tuesday, February 24th, 2015 AT 6:14 PM
Tiny
DKIRK
  • MEMBER
  • 4 POSTS
First, thank you for replying.
The 2014 has a cutout that you can pull out and find the fuses.

However, on my 2015 there is nothing but flat dash under the switches on the dash.

Also, the link did not work.
Was this
answer
helpful?
Yes
No
+1
Wednesday, February 25th, 2015 AT 4:22 AM
Tiny
DKIRK
  • MEMBER
  • 4 POSTS
Hold on! Rechecked, located the panel on side of dash. Cannot see with the door closed.
Thank you again.
Was this
answer
helpful?
Yes
No
+1
Wednesday, February 25th, 2015 AT 6:16 AM
Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,885 POSTS
That's correct. The door must be open to access it. Did you find it?
Was this
answer
helpful?
Yes
No
Wednesday, February 25th, 2015 AT 3:49 PM
Tiny
DKIRK
  • MEMBER
  • 4 POSTS
Yes, did locate the door.
I was actually looking for an easy way to make the 12 volt outlets in the 2015 Nissan Rogue "on" all the time.
It would seem that without taking the interior apart, there just is no easy way. I remember in days gone by with glass fuses, you could get on hot side of fuse to get the 12 volts, and put inline fuse in. I can't even tell which fuse is for the 12 volt outlet much less bypass the fuse.
Here's the test.
Can this be done?
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Thursday, February 26th, 2015 AT 5:14 AM
Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,885 POSTS
If you want a power supply with the key off, simply locate a fuse that is hot all the time. From that fuse, run a power supply where you want it, and yes, use an inline fuse to protect the circuit.

Is there an easy way? No. It's nearly impossible because of having no room to work.
Was this
answer
helpful?
Yes
No
+1
Friday, February 27th, 2015 AT 5:13 AM

Please login or register to post a reply.

Sponsored links