2010 Mercury Mariner Heat and Air Blower Control

2010 MERCURY MARINER

38,500 MILES

JOE SOBO

MEMBER
1 POST

I have a 2010 Mercury Mariner and just recently the blower controls have stopped working on numbers 1,2 and 3, but it continues to work on high number 4. Both the heat and the air do the same. I have checked fuses per the owners manual and they seem to be fine. Any suggestions would be appreciated before I head to the dealer. Thank-you.

Oct 22, 2013 at 6:34 AM

HMAC300

✓ASE Certified Mechanic
48,601 POSTS

check for power at the blower resistor or just get one and replace it red arrow in pic points to it.

Image (Click to enlarge)

Professional Diagram for 2CarPros Members
Click here to log in and view diagram.

Oct 22, 2013 at 6:58 AM

HMAC300

✓ASE Certified Mechanic
48,601 POSTS

also if it'snot that then you can take to any garage to get it scanned to see what else is wrong but it's probably resistor unless this is automatic temp control

Oct 22, 2013 at 6:59 AM

WRENCHTECH

✓ASE Certified Mechanic
20,761 POSTS

hmac300 is correct here. I just wanted to add one point. If you are testing the signals coming into the resister for the various speeds, it's a ground signal that you are looking for. The resister is on the ground side of the circuit.

Oct 22, 2013 at 8:42 AM

Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.