I have a 2006 Jeep Wrangler that is an automatic & even when it is in 2WD the 4WD light still stays on. How do I fix this?
Dec 2, 2010 at 6:14 PM
2006 Jeep Wrangler 4WD light repair
2006 JEEP WRANGLER TJ
CMBATTLES
- MEMBER
- 1 POST
Advertisement
CJ MEDEVAC
- ✓ASE Certified Mechanic
- 11,004 POSTS
Did the best I could do
Maybe this is the switch you have--causing you problems--I do not know its location, I would assume on the TRANSFER CASE!.....I would think unplugging it would kill the light, just to verify this is the switch to be examined or replaced.
One more time, ARE YOU SURE THE VEHICLE IS OUT OF 4X4...Not just what the selector says?
The Medic
Maybe this is the switch you have--causing you problems--I do not know its location, I would assume on the TRANSFER CASE!.....I would think unplugging it would kill the light, just to verify this is the switch to be examined or replaced.
One more time, ARE YOU SURE THE VEHICLE IS OUT OF 4X4...Not just what the selector says?
The Medic
Dec 2, 2010 at 6:51 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.