2003 Jeep Liberty Fan Noise

165,000 MILES • 3.7L • 4 CYL • 4WD • AUTOMATIC
Avatar
TUCKSSIS
  • MEMBER
  • 2 POSTS
My fan is loose, I have checked the belts and they are still good, not warped, cracked. Not quite sure what it could be a friend suggested it could be the bearings if that is the case how do I get my fan out? Thanks for your help.
Jan 25, 2014 at 10:56 AM
Advertisement
Avatar
KNOWLEDGE IS POWER
  • EXPERT
  • 1,136 POSTS
if the fan is loose then it could be the fan clutch and/or the water pump. the latter is usually the cause and the shroud and belt and coolant have to come out. then take out the water pump. best to do this when the engine is cold so as not to get burned
Jan 25, 2014 at 11:24 AM
Avatar
MLDANIELS2000
  • ✓Experienced Mechanic
  • 227 POSTS
Check for fan wobble by pushing on fan fins. If pulley moves with fan, then water pump bearings are bad. Will need water pump. You can get a loaner tool set for removing fan clutches at any parts store. Basically big thin wrenches. May need to use a hammer to impact the wrench to break it loose. Best to do with belt still on. May have to use a tool to hold the pulley in place such as a long pry bar. To remove fan clutch with fan, shroud will need to be removed as well.
Jan 25, 2014 at 1:04 PM
Avatar
TUCKSSIS
  • MEMBER
  • 2 POSTS
Thank you for your help
Jan 26, 2014 at 10:45 PM
Avatar
MLDANIELS2000
  • ✓Experienced Mechanic
  • 227 POSTS
Very welcome, if more info needed just reply back.
Jan 27, 2014 at 3:51 AM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle