2003 Chevy Cavalier

2003 CHEVROLET CAVALIER
Avatar
LILJENJEN
  • MEMBER
  • 2 POSTS
I have a 2003 chevy cavailer, and I was driving to take a friend home and on the way home, I was in the turn around lane, when the rpm to about 2 like it was about to lunge forward, if I would have not had my foot on the break harder, it would of speed up and went. The 2nd time the rpm was when I was in the bank, putting money in the atm. I had the car in park, and the rpm raced high again till about 2 then came back down. What could be the problem?
Feb 3, 2011 at 5:59 PM
Advertisement
Avatar
JDL
  • ASE Certified Mechanic
  • 16,098 POSTS
  • ASE Certified Mechanic
I'd clean the throttle-body and check the iac/idle air control. Check for any applicable trouble codes. Some of the national brand autostores used to check codes for free.
Feb 3, 2011 at 6:24 PM
Avatar
LILJENJEN
  • MEMBER
  • 2 POSTS
Thanks. Another question, its about the same car. I fill 2003 Chevy Cavalier with gas, after driving from point A to point B, once I put the car in park, the gas gage needle will move down then up, then back down, and it will go down about an inch or 2 further than where it's suppose to be.
Feb 3, 2011 at 7:41 PM
Avatar
JDL
  • ASE Certified Mechanic
  • 16,098 POSTS
  • ASE Certified Mechanic
The fuel level sending unit sends a signal to the pcm, the pcm sends signal to instrument cluster. I did see a tsb for erratic fuel gage reading, it said to replace the sending unit in the gas tank.

There are codes for the sending unit circuits, you might have the codes checked.
Feb 3, 2011 at 8:14 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.