SPONSORED LINKS

2001 Chrysler Sebring Engine

Tiny
HUNTEREMO
  • MEMBER
  • 2001 CHRYSLER SEBRING
  • 3.0L
  • V6
  • 2WD
  • AUTOMATIC
  • 172,450 MILES
I went to start my car today everything great! So I put in to drive car reved up so I added pressure to pedal to make car drive did not move at all I added more. Throdel car moved after but it took a lot so whe. I was stopped put in reverse same thing it would not move! I am being told it might be stuck in 3 gear but engine light has come one could the tranmistion be dead?
SPONSORED LINKS
Friday, June 26th, 2015 AT 6:05 PM

1 Reply

Tiny
CARADIODOC
  • MECHANIC
  • 33,916 POSTS
The Check Engine light is telling you the computer detected a problem and set a diagnostic fault code to tell you what it saw. The place to start is by reading those codes. Chrysler makes doing that yourself real easy. Cycle the ignition switch from "off" to "run" three times within five seconds without cranking the engine, leave it in "run", then watch the code numbers appear in the odometer display.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Friday, June 26th, 2015 AT 10:47 PM

Please login or register to post a reply.

Related Engine Revs Up Content

Idle Air Control Motor Replacement
GUIDE
Idle Air Control Motor Replacement
The idle air control motor or idle speed control motor is designed to adjust the air flow into the intake manifold at engine idle. Engine idle speed is monitored by the PCM...
VIEW MORE

Sponsored links