2000 Dodge Durango Transmission

Tiny
EDITHJUAREZ
  • MEMBER
  • 2000 DODGE DURANGO
  • 2.3L
  • V8
  • 4WD
  • AUTOMATIC
  • 236,000 MILES
I braked too hard, when I tried to put the car in reverse it would not move. I then tried to put it in park and it made a loud noise, like metal against metal. It only makes a noise in park, if it is in drive or neutral it just won't move.
Thursday, March 26th, 2015 AT 9:21 PM

4 Replies

Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,755 POSTS
Braking too hard won't hurt the trans. Tell me, when it's in drive, is there a load on the engine like it's trying to move but can't?
Was this
answer
helpful?
Yes
No
Friday, March 27th, 2015 AT 5:34 AM
Tiny
EDITHJUAREZ
  • MEMBER
  • 3 POSTS
When the car is in Drive it acts as if it were Neutral, same goes for R, 1 and 2. If the 4WD is activated the car will move normally, but can I drive around with that on?
Was this
answer
helpful?
Yes
No
Friday, March 27th, 2015 AT 9:15 AM
Tiny
EDITHJUAREZ
  • MEMBER
  • 3 POSTS
By the way, thanks for the speedy response!
Was this
answer
helpful?
Yes
No
Friday, March 27th, 2015 AT 9:27 AM
Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,755 POSTS
Okay, if you can drive it in 4wd only, something happened either to the rear axle, rear drive shaft, or the differential. That isn't a good thing. First, check to make sure the drive shaft is secure and not hanging down. Next, place the vehicle in 2wd and place it in gear and have a helper watch the rear drive shaft to see if it is turning (even if the car isn't).

Let me know what you find.
Was this
answer
helpful?
Yes
No
Friday, March 27th, 2015 AT 9:53 PM

Please login or register to post a reply.

Sponsored links