Howdy bluelightnin6,
Thank's for the info and quick response. I'm not sure how the points system works for the feed back section of the forum but would like to leave a positive post so I'll check into that.
As to the ABS schematics, they're great and I was able to run a few checks. One system's check I performed was a continuity test for the ele. Motor which gave me about.5 ohm and along with the resistance of my meter's leads I would guess the motor had a dead short. When I check the the connector end to the motor there's power so the motor's not blowing any fuses. The motor is held to the ABS housing via Torx bolts so I'm considering pulling it to run a few tests. As far as the wheel sensors, all sensors show continuity and there's 5 volts at all sensor connectors. Will keep at it!
Tuesday, November 9th, 2010 AT 6:16 PM