Friday, March 1st, 2013 AT 7:23 AM
KATIEROYCROFT
- MEMBER
- 1997 HONDA CIVIC
- 17,500 MILES
How to install a neutral safety switch
How to install a neutral safety switch
1 Reply
KHLOW2008
- MECHANIC
- 41,814 POSTS
The switch is on the clutch pedal support.
Disconnect the wire connector.
Loosen the lock nut and turn the switch countre-clockwise to remove.
Install new switch.
Turn until switch button is fully compressed without clutch pedal moving.
Back off 1/2 a turn and tighten the lock nut.
Reconnect the wire connector.
Disconnect the wire connector.
Loosen the lock nut and turn the switch countre-clockwise to remove.
Install new switch.
Turn until switch button is fully compressed without clutch pedal moving.
Back off 1/2 a turn and tighten the lock nut.
Reconnect the wire connector.
SPONSORED LINKS
Was this helpful?
Yes
No
Friday, March 1st, 2013 AT 2:13 PM
Related Transmission Gear Position Sensor Replace/Remove Content
Sponsored links
SPONSORED LINKS
