I have a 1995 Silverado Z71 4X4 with TBI.

Tiny
CRJ
  • MEMBER
  • 1995 CHEVROLET SILVERADO
  • V8
  • 4WD
  • AUTOMATIC
  • 2,696,248 MILES
I had a 3-inch crack beside the freeze plug on the motor block. The motor is a 350 5.7 with throttle body. I poured water into the radiator and it can out the crack in a steady stream. I preceded to J.B. Weld the crack to seal it closed and stop the leak. This fixed the crack and the leak coming from the crack but when I pulled the plug in the bottom of the oil pan, a large amount of water came from the oil pan followed by sludged oil. Should I replace the lower intake gasket and head gasket even though there was a crack in the motor block? I am looking for the most inexpensive resolution to this problem. I plan to do the repairs myself although I am not a licensed or experienced automotive mechanic. Please keep this fact in mind as you respond. Thank you for your time.
Tuesday, March 1st, 2011 AT 8:30 PM

9 Replies

Tiny
DOCFIXIT
  • MECHANIC
  • 18,828 POSTS
Did coolant freeze in engine causing crack?
Was this
answer
helpful?
Yes
No
Tuesday, March 1st, 2011 AT 8:44 PM
Tiny
CRJ
  • MEMBER
  • 5 POSTS
Yes.
Was this
answer
helpful?
Yes
No
Tuesday, March 1st, 2011 AT 8:45 PM
Tiny
DOCFIXIT
  • MECHANIC
  • 18,828 POSTS
Likely crack in external block not only crack believe cylinder cracked also
Was this
answer
helpful?
Yes
No
Tuesday, March 1st, 2011 AT 8:49 PM
Tiny
CRJ
  • MEMBER
  • 5 POSTS
Will I have to replace the motor?
Was this
answer
helpful?
Yes
No
Tuesday, March 1st, 2011 AT 9:04 PM
Tiny
DOCFIXIT
  • MECHANIC
  • 18,828 POSTS
Yes if oil still out of engine put water in Radiator if it comes out pan drain then yes need new block
Was this
answer
helpful?
Yes
No
Tuesday, March 1st, 2011 AT 9:17 PM
Tiny
CRJ
  • MEMBER
  • 5 POSTS
Tryed your suggestion and water came immediately from oil pan drain. Would replacing just the block itself fix my problem?
Was this
answer
helpful?
Yes
No
Tuesday, March 1st, 2011 AT 9:26 PM
Tiny
DOCFIXIT
  • MECHANIC
  • 18,828 POSTS
350 pretty common salvage engine best way to go
Was this
answer
helpful?
Yes
No
Tuesday, March 1st, 2011 AT 9:54 PM
Tiny
CRJ
  • MEMBER
  • 5 POSTS
Are all 350 blocks the same?
Was this
answer
helpful?
Yes
No
Tuesday, March 1st, 2011 AT 10:09 PM
Tiny
DOCFIXIT
  • MECHANIC
  • 18,828 POSTS
Yes but don't go back more than 1990
Was this
answer
helpful?
Yes
No
Wednesday, March 2nd, 2011 AT 1:44 PM

Please login or register to post a reply.

Sponsored links