How can i take apart the ignition in my 94 topaz?
Mar 27, 2011 at 10:23 PM
94 Topaz
1994 MERCURY TOPAZ
TANAMARIEE123
- MEMBER
- 1 POST
Advertisement
RASMATAZ
- ✓ASE Certified Mechanic
- 75,992 POSTS
REMOVAL
Disarm airbag system, if equipped.
Disconnect battery ground cable, then remove five steering column shroud attaching screws.
Disconnect battery ground cable, then remove five steering column shroud attaching screws.
Remove two bolts and two nuts attaching steering column to column bracket, then lower steering column assembly to seat and remove column shrouds.
Disconnect ignition switch wire connector, then rotate ignition switch lock cylinder to the RUN position.
Remove the two retaining screws connecting the switch to the lock cylinder housing.
Detach ignition switch from actuator pin, then remove switch.
Disarm airbag system, if equipped.
Disconnect battery ground cable, then remove five steering column shroud attaching screws.
Disconnect battery ground cable, then remove five steering column shroud attaching screws.
Remove two bolts and two nuts attaching steering column to column bracket, then lower steering column assembly to seat and remove column shrouds.
Disconnect ignition switch wire connector, then rotate ignition switch lock cylinder to the RUN position.
Remove the two retaining screws connecting the switch to the lock cylinder housing.
Detach ignition switch from actuator pin, then remove switch.
Mar 27, 2011 at 10:33 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.