Why are my gears meshing together/wont go into gear

Tiny
PRELUDE94SI
  • MEMBER
  • 1994 HONDA PRELUDE
I did an engine swap and took off transmisson and put back on now it wont go past forth gear so no fith or reverse and noow all the four gears mesh and like I can switch from 3rd to 1st w/out going into the neutral postion why might this happen
Monday, January 16th, 2012 AT 4:37 AM

5 Replies

Tiny
MHPAUTOS
  • MECHANIC
  • 31,937 POSTS
Check that the selector cables are secure, check shifter quadrant for excessive wear.
Was this
answer
helpful?
Yes
No
Monday, January 16th, 2012 AT 5:13 AM
Tiny
FIXITMR
  • MECHANIC
  • 9,990 POSTS
Did you mess up the linkage? What had to be disassembled to get trans out?
Was this
answer
helpful?
Yes
No
Monday, January 16th, 2012 AT 5:25 AM
Tiny
PRELUDE94SI
  • MEMBER
  • 2 POSTS
Mhpautos what is it if its not that I just wanna go worst case senario
Was this
answer
helpful?
Yes
No
Monday, January 16th, 2012 AT 5:34 AM
Tiny
FIXITMR
  • MECHANIC
  • 9,990 POSTS
Did you drain trans fluid and then replace when done?
Was this
answer
helpful?
Yes
No
Monday, January 16th, 2012 AT 6:09 AM
Tiny
MHPAUTOS
  • MECHANIC
  • 31,937 POSTS
Sounds as if the selector linkages or cables are loose, look at this first.
Was this
answer
helpful?
Yes
No
Monday, January 16th, 2012 AT 8:10 AM

Please login or register to post a reply.

Sponsored links