SPONSORED LINKS

I'm trying to change the rear breaks on my 93.

Tiny
ANONYMOUS
  • MEMBER
  • 1993 TOYOTA CELICA
  • 195,000 MILES
I'm trying to change the rear breaks on my 93 toyota celica gts. It has one bolt to hold the caliper and a pin on top. My problem is it apears that the caliper is too far back to go over the new break pads. It needs to move out about an 1/8 of an inch but it won't slide on the pin. It moves up and down with ease but not forward and backwards at all. Is there something that I haven't did?

SPONSORED LINKS
Saturday, November 17th, 2012 AT 11:27 PM

1 Reply

Tiny
WRENCHTECH
  • MECHANIC
  • 20,761 POSTS
The pin could be corroded and binding and that needs to be very free and well lubricated for the brakes to work correctly. You need to swivel it back and forth until you can get it all the way slid off the pin and then clean and lubricate the pin and hole until is slides freely.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Saturday, November 17th, 2012 AT 11:34 PM

Please login or register to post a reply.

Related Caliper Replace/Remove Content

Brake Caliper Replacement
GUIDE
Brake Caliper Replacement
A brake system caliper is responsible for containing hydraulic brake pressure and is then applied to the brake pads which then helps stop the car via the brake rotors. This...
VIEW MORE

Sponsored links