How do I change the water pump on a 1993 Protege dx model SOHC 4cyl

Tiny
MOOSEHUNTER429
  • MEMBER
  • 1993 MAZDA PROTEGE
  • 20,000 MILES
I have the upper timing cover off, do I need to remove the lower section? How many bolts in the pump? How do I remove the timing belt?
Wednesday, November 30th, 2011 AT 8:46 PM

1 Reply

Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
Removal & Installation (SOHC)

Drain engine coolant. Disconnect negative battery cable. Position No. 1 cylinder at TDC of compression stroke. Remove right side cover and undercover. Remove drive belts and water pump pulley. Remove timing belt.
See TIMING BELT under REMOVAL & INSTALLATION. Unbolt water inlet pipe from water pump. Water pump inlet pipe has lower radiator hose and by pass pipe attached to it. Remove water pump. To install,
reverse removal procedure. Tighten bolt to specification. See TORQUE SPECIFICATIONS. 14-19 ft lbs on pump bolts.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
+3
Thursday, December 1st, 2011 AT 12:34 AM

Please login or register to post a reply.

Related Water Pump Replace/Remove Content

Water Pump Replacement
VIDEO
Water Pump Replacement
Instructional repair video
VIEW MORE

Sponsored links