SPONSORED LINKS

1992 Holden Jackaroo CV BOOTS

Tiny
STAN411
  • MEMBER
  • 1992 HOLDEN JACKAROO
  • 3.1L
  • 4 CYL
  • TURBO
  • 4WD
  • MANUAL
  • 265,000 MILES
JUST BOUGHT MY 1992 3.1 LTR TURBO DIESEL jACKAROO, The dust boots on the front axle and cv joints are damaged, how do I remove and replace them, I Have no Manual it is a 4x4, do Ineed to remove the front wheel and brake rotor to slip the axle, s out and put the boots on regards Stan
SPONSORED LINKS
Saturday, February 1st, 2014 AT 3:44 AM

1 Reply

Tiny
KNOWLEDGE IS POWER
  • MECHANIC
  • 1,136 POSTS
Yes you do. Make sure that you clean and check the joints before putting the boots back on and you must put in new grease. You may want to check on the price of an axle assembly so you can weigh out your decision if theres any doubt of the integrity of the joints. They generally aren't very expensive
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Saturday, February 1st, 2014 AT 7:51 AM

Please login or register to post a reply.

Related CV Axle Replace/Remove Content

CV Axle Replacement
GUIDE
CV Axle Replacement
All front wheel drive and independent rear suspension cars utilize a CV axle to deliver power from the engine to the wheels. These CV axles have a six balls inside a CV...

Sponsored links