Where is Powertrain Control Module on a 1991 Dodge Dynasty 3.3L and how do I replace it?

1991 DODGE DYNASTY
23 MILES
Avatar
NATE05BEARS
  • MEMBER
  • 2 POSTS
It's a 3.3L 6 cylinder. The steering pump is going out of it. We have already replaced the crank shaft, the oxygen and cam sensor. We spliced in some new wires. We put in a fusible link. We cleaned up the battery cables. We put in a new coil pack.
Mar 9, 2012 at 6:55 PM
Advertisement
Avatar
ASEMASTER6371
  • ✓Experienced Mechanic
  • 52,796 POSTS
it is on the left front of the engine compartment. Why are you replacing it??

Roy
Mar 9, 2012 at 8:05 PM
Avatar
NATE05BEARS
  • MEMBER
  • 2 POSTS
I am replacing it because the car runs great but we've had a few problems. First we fixed the fuel rail but right after we fixed we bumped something and it wouldn't start. That's when we went to a cam sensor. Now it will start fine the first time. Once we run it, though, and shut it off it won't start. It does start hard sometimes also. As you see from my first post that's all the stuff we replaced.
Nate
Mar 10, 2012 at 2:07 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.