How do I replace AC control panel

Removal

1. Disconnect� negative� ( )� cable� at� battery.
2. Remove� steering� column� hole� cover� and� glove� box.
3. Remove� center� lower� garnish� (1)� and� then� disconnect� rear� defogger� switch� connector� and� fog� lamp� switch� connector� (if� e

Fig.� 18:� Removing� Center� Lower� Garnish
Courtesy� of� SUZUKI� OF� AMERICA� CORP.

4. Disconnect� air� flow� selector� cable� (1)� and� temperature� selector� cable� (2).

Fig.� 19:� Disconnecting� Selector� Cables
Courtesy� of� SUZUKI� OF� AMERICA� CORP.

5. Remove� heater� controller� (1)� from� instrument� panel, � then� disconnect� related� connector.

Fig.� 20:� Removing� Heater� Controller
Courtesy� of� SUZUKI� OF� AMERICA� CORP.

Installation

Reverse� removal� procedure� to� install� heater� controller� noting� the� following� instructions.

? Adjust� the� following� items.

1. Set� air� flow� selector� (1)� and� temperature� selector� (2)� as� shown� in� figure.

Fig.� 21:� Setting� Selectors
Courtesy� of� SUZUKI� OF� AMERICA� CORP.

2. Push� air� flow� selector� link� (1)� and� temperature� selector� link� (2)� fully� in� arrow� direction.
3. Fix� air� flow� selector� cable� (3)� and� temperature� selector� cable� (4)� with� clamp� in� position� as� shown� in� figure.

Fig.� 22:� Fixing� Selector� Cables